福建莆田全自动挂历单/双线圈装订机 厂家电话价格报价

aft520价格：200.00元/台 最小起订量：1 台 供货总量：999 台 发货期限：自买家付款之日起5天内发货 有效期至：长期有效

ble shooting

8.1 冲孔系统故障排除 Punching system trouble shooting

   8.1.1   故障现象：全自动台历 挂历 笔记本单/双线圈装订机机器不动 Symptom: The machine does not move

           产生原因：电源没有接通或者保护开关触发异常。

Cause: The power supply is not turned on or the protection switch is triggered
  排除方法：查看电源开关是否已经接通，保护开关有无异常， 配电箱内空气开关是否断开。

Remedy: Check whether the power switch is switched on, whether the protection switch is abnormal or not, and the air switch in the distribution box is disconnected
8.1.2异常现象：全自动台历 挂历 笔记本单/双线圈装订机毛边大

Abnormal phenomenon: big hair
  产生原因：纸张太厚，冲针严重磨损

Cause: The paper is too thick and the punch is severely worn
  排除方法：正常运行纸张厚度建议在1-6mm之内；如果是冲针磨损严重请更换。Remedy: normal operation of the paper thickness is recommended within 1-6mm; if the pins wear, please replace.

8.2 全自动台历 挂历 笔记本单/双线圈装订机机器手送料系统的故障排除 The feed belt system trouble shooting

   8.2.1 故障现象：全自动台历 挂历 笔记本单/双线圈装订机机器不动Symptom: The machine does not move

         产生原因：电源没有接通或者光电开关触发异常。Cause: The power supply is not turned on or the photoelectric switch triggers an abnormality
         排除方法：查看电源开关是否已经接通，光电开关有无异常。Remedy: Check whether the power switch is turned on, the photoelectric switch is abnormal.

   8.2.2  异常现象：全自动台历 挂历 笔记本单/双线圈装订机机械手抓取和送料位置不对             Abnormal phenomenon: the robot grab and feeding position is wrong

   产生原因：皮带拉长松弛或者是皮带固定块1不牢靠。        Cause: The belt is stretched or the belt is fixed

   排除方法：将皮带张紧到合适的松紧度，调整好机械手的位置锁紧皮带固定块。Remedy: Tighten the belt to the appropriate tightness, adjust the position of the robot to lock the belt fixed block.